Infiniti QX30 Forum banner
1 - 3 of 3 Posts

· Super Moderator
662 Posts
In the rear cargo area there is a panel on each side of the vehicle. Turn the latch and remove the panel.

Behind the panel you'll find the taillight harness connector, and you may disconnect it.

On the body inside of the taillight there is a plastic cover (normally covered by the closed tailgate). There are five pawls holding it in place. Use a trim removal tool to pry up and remove the cover.

Behind the cover there are two bolt that hold the taillight in place. Remove the bolts.

The taillight also has three clips holding it in. Apply painters tape along the edges of the paint, next to the tail light, and use a trim removal tool to pry the taillight away from the body.
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.