Infiniti QX30 Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
9 Posts
Discussion Starter · #1 ·

Attachments

· Registered
Joined
·
3 Posts
Just changed my belt. Here are the parts needed.
Undo the oil pan cover to access the belt and tensioner. I had to have someone hold the new belt on the upper idler and alternator pully while I pulled the belt over the a/c pully.
Took 15 minutes. I have attached someone else's notes.


Amazon.com: Bonbo Serpentine Belt Tool for Mercedes Benz M270 Engine Replace JTC 4346 & MM# 270589000700 : Automotive
Amazon.com: Mercedes-Benz 002 993 11 96, Serpentine Belt : Automotive
Do you have the rest of the paper? The attached PDF picks up at the tightening. There is no removal and routing the new belt.
 

· Registered
Joined
·
9 Posts
Discussion Starter · #3 ·
I made the pdf out of pics from the forum. The first page shows the belt route. You just put the belt tool in the hole and push towards the firewall. The torque spec u see in doc is for replacing the tensioner. If you have to replace that then. You will need to pull tire, fender protector, and wheel liner. To access the the tensioner bolts.
 
1 - 3 of 3 Posts
Top