Infiniti QX30 Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
Hi all!
I buy used qx30 2018 years.
From the key and the handle do not open the rear doors.I checked the fuses, they are all intact. The computer does not give errors. Any body have same problem? How to fix it ?

p.s. Can someone please share the electrical and mechanical diagrams of the doors?
 

·
Registered
Joined
·
13 Posts
Hi all!
I buy used qx30 2018 years.
From the key and the handle do not open the rear doors.I checked the fuses, they are all intact. The computer does not give errors. Any body have same problem? How to fix it ?

p.s. Can someone please share the electrical and mechanical diagrams of the doors?
This may sound silly but have the key fob batteries replaced? Are the locks on the rear doors locked (button down)?
 

·
Registered
Joined
·
6 Posts
Discussion Starter · #4 ·
Resolved:
remove the door trim;
from drill a map of the window regulator; unscrew and remove the glass;
remove the protective cover of the lock (one bolt and several latches);
remove the window card;
break the lock with pliers (piece by piece, carefully without damaging anything else, break off the pieces from the lock body);
when the mechanism is exposed, the lock will open.

then we unscrew everything else and change the lock to a new one.
 

·
Registered
Joined
·
6 Posts
Discussion Starter · #5 ·
Resolved:
remove the door trim;
from drill a map of the window regulator; unscrew and remove the glass;
remove the protective cover of the lock (one bolt and several latches);
remove the window card;
break the lock with pliers (piece by piece, carefully without damaging anything else, break off the pieces from the lock body);
when the mechanism is exposed, the lock will open.

then we unscrew everything else and change the lock to a new one.
some additional things, may be some one help’s:
after removing the panel, before breaking the lock, the following:
1 on the lock from the side where the cable of the outer handle comes in there is such a cover with latches (picture 1);
2. unfasten the latches;
3. There will be a threaded gear under it, this gear pulls the cable (picture 2);

This may be a solution, since judging by the information and design, the cable will unfasten and the lock will stop working. should help.
If not, then break it.

Automotive tire Toy Motor vehicle Gas Automotive design

Water Liquid Hood Fluid Automotive lighting
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top